xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config ports
from the master. If one connection is set for 1000 master, the
other side of the connection must be set for 1000 slave. Any other
configuration will result in a link down status for both ports. None
denotes the Switch will serve no role for stacking.
flow_control [enabled | disabled] – Enable or disable flow control
for the specified ports.
learning [enabled| disabled] − Enables or disables the MAC
address learning on the specified range of ports.
state [enabled | disabled] − Enables or disables the specified
range of ports.
description <desc 32> - Enter an alphanumeric string of no more
than 32 characters to describe a selected port interface.
clear – Enter this command to clear the port description of the
selected port(s).
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the speed of port 3 of unit 1 to be 10 Mbps, full duplex, learning and state enable:
DES-6500:4#config ports 1:1-1:3 speed 10_full learning enabled state enabled
Command: config ports 1:1-1:3 speed 10_full learning enable stated enabled
Success.
DES-6500:4#
show ports
Purpose Used to display the current configuration of a range of ports.
Syntax
show ports {<portlist>} {description}
Description This command is used to display the current configuration of a
range of ports.
Parameters
{<portlist>} − Specifies a range of ports to be displayed. The port
list is specified by listing the lowest slot number and the beginning
port number on that slot, separated by a colon. Then the highest
slot number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
slot number 1, port 3. 2:4 specifies slot number 2, port 4. 1:3-2:4
specifies all of the ports between slot 1, port 3 and slot 2, port 4 −
in numerical order.
{description} – Adding this parameter to the command will allow
the user to view previously configured descriptions set on various
ports on the Switch.
Restrictions None.
Example usage:
To display the configuration of all ports on a standalone switch:
26
