Filter
Top Products
NOTES:
Surface
Mounting
-
With Access
If
you
have access underneath
the
mounting
surface,
use the
gasket
furnished with the GPS
module as a
template.
Mark and drill four
5.5mm
(7/32")
holes for the
mounting
screws and one 14 mm
(9/16")
hole for the module's cable.
Attach the cable to the module and
pass
it
down
through
the hole
in
the
gasket
and the
mounting
surface. Use
four 5 mm
screws,
flat
washers,
and
lock washers to fasten the OPS
module to the
mounting
surface. Route the 25' GPS cable to
the
UltraNavGPS.
7
I
y///////////////////
/////////////////////////////////////////A
SCREW
Surface
Mounting
-
Without Access
If
you
don't have access to the back side of the
mounting
surface,
use
the "cleats"
supplied
with the UltraNavGPS.
(Note:
This is
assuming
you
can "snake" the
module's cable to a location that is accessable.
A
hole
will
still
need to be drilled in the
mounting
surface for the
cable.)
Using
the
gasket
as
a
template,
mark and drill the 9/16" hole for the
cable. Attach
the cable to the module and
drop
the
other end of the
cable
through
the
gasket
and down the hole. Place the module
on the
gasket.
Slide the "cleats" onto each end of the module and
(using
the
cleats as
templates)
mark four holes for 5 mm
(#10) mounting
screws.
Drill
the
holes,
then
replace
the cleats on the module and fasten them
to the
mounting
surface with 5 mm
(#10)
screws. Route the
cable to
the UltraNavGPS.
4
PDF compression, OCR, web-optimization with CVISION's PdfCompressor