Filter
Top Products
3. PLOTTER OPERATION
3-32
Editing a waypoint from the plotter display
You may edit waypoints from the plotter display as follows:
1. Press the [MENU] key followed by the C:WAYPOINTS/ROUTES and
A:WAYPOINTS soft key to open the waypoint menu.
2. Press the C:WAYPOINT BY CURSOR soft key.
3. Operate the trackball to place the cursor on the waypoint which you want to
change. A flashing diamond mark appears on the waypoint when it is
correctly selected.
4. Press the D:EDIT/MOVE soft key. Three soft keys replace the D:EDIT/MOVE
soft key:
B:EDIT WPT: Edit from the waypoint entry window.
C:MOVE WPT: Move waypoint to new position with the cursor.
D:ERASE WPT: Erase waypoint. See paragraph 3.8.3.
5. Press the appropriate soft key. For the “EDIT WPT,” the waypoint entry
window appears; edit data as appropriate. For “MOVE WPT,” do the
following:
a) Operate the trackball to place the cursor on the location desired for the
waypoint. A line connects previous position and new position.
b) Push the [ENTER] knob. The waypoint moves to the cursor position and its
position is changed on the waypoint list. If the waypoint is set as
destination or is part of a route, you are asked if you are sure to move the
waypoint. In this case, push the [ENTER] knob to move the waypoint, or
press the [CLEAR] key to cancel.
c) Press the [MENU] key to finish.
BRIDGE
WP-002
34° 22. 345’N 86.6°M TRIP NU
080° 22. 345’E
4.53nm 99.9 nm
Press to alternately display
range/bearing from own ship
to cursor, range/bearing from
original waypoint position to
cursor position.
Below is an example of the
range/bearing from original
waypoint position to cursor
position.
FISH
(2) Drag cursor to new position,
then push the [ENTER] knob.
(1) Select waypoint to move,
then press D:EDIT/MOVE
and C:MOVE WPT soft keys.
16.0nm
+
Range and bearing from
own ship to cursor
34° 22. 3456’N FROM 5.3°M
080° 22. 3456’E
FISH 1.45 nm
+
CANCELE
RNG
BRG
C
Plotter display
offered by Busse-Yachtshop.de