Filter
Top Products
2. RADAR OPERATION
2-28
2.21 Outputting TLL Data
Target position data can be output to units of the network and shown on their
plotter screen with the TTL mark (
X
). This function requires position and
heading data.
1. Operate the trackball to place the cursor on the target whose position you
wish to output.
2. If not displayed, press the [HIDE/SHOW] key to display the radar soft keys.
3. Press the D:TARGET soft key.
Requires ARP circuit board
in Model 1800/1900-BB series
NavNet radar. Not shown
otherwise.
TARGET
359.9 ˚R
11.70
nm
+
12/
H-UP
3nm
LP
319. 9
°M
ACQC
TARGET
INFO
D
RETURNE
TRAILA
TLL
OUTPUT
B
TARGET soft keys
4. Press the B:TLL OUTPUT soft key to output target position data. The TLL
mark appears on the plotter screen at the target’s position the moment the
B:TLL OUTPUT soft key was pressed. Further, that position is recorded as a
waypoint on all NavNet units, under the youngest empty waypoint number on
each NavNet unit.
5. Press the E:RETURN soft key to finish.
Note: The screen of the TLL recipient may be temporarily interrupted when
receiving TLL from another NavNet unit. Press any key to restore normal
operation.
offered by Busse-Yachtshop.de