Filter
Top Products
1. OPERATIONAL OVERVIEW
1-10
1.5.4 Selecting image source
When more than one network radar or network sounder is connected to the
equipment, you may select an image source for each as shown below. This is
not necessary when only one network radar or network sounder is connected.
1. Press the [DISP] key.
2. Press any soft key to show the following display.
▲
SELECT
SOURCE
IF THERE IS MORE THAN
ONE NETWORK RADAR OR
ECHO SOUNDER, YOU MAY
SELECT THE IMAGE
SOURCES FOR DISPLAY.
RADAR SOURCE
RADAR
- - -
SOUNDER SOURCE
SOUNDER
-
AUX SOURCE WXFAX
-
- -
IP ADDRESS
172.031.003.007
HOST NAME
RADAR
- - -
RETURNE
EDITA
Select source menu
3. Use the trackball to select RADAR SOURCE, SOUNDER SOURCE or AUX
SOURCE as appropriate, then press the A: EDIT soft key.
RADAR SOURCE SOUNDER SOURCE
Radar source Sounder source Aux source
RADAR
- - -
SOUNDER
-
AUX SOURCE
WXFAX
- - - - -
Radar source and sounder source windows
4. Use the trackball and alphanumeric keys to enter source name: Adjust the
trackball to select location and enter character with the alphanumeric keys.
5. Push the [ENTER] knob to set.
6. Press the [DISP] key to finish.
Note: Source names are determined at installation. For example, the source
names for radars in a two-radar system might be “RADAR” and
“RADAR1”.
offered by Busse-Yachtshop.de