Filter
Top Products
3. PLOTTER OPERATION
3-52
3.11 Alarms
The plotter section has eight conditions which generate both audio and visual
alarms: arrival alarm, anchor watch alarm, XTE (Cross Track Error) alarm,
proximity alarm, speed alarm, trip alarm, water temperature alarm and bottom
alarm. (The bottom and water temperature alarms, which require depth and
water temperature data, may also be set on the sounder alarm menu. For these
alarms see Chapter 4.)
You may set up the plotter alarms on the ALARM menu, which may be displayed
by pressing the [ALARM] key.
ALARM2
ALARM1
Page 2Page 1
AUDIO ALARM INTERNAL BUZZ
ARRIVAL ALARM OFF 0.010nm
ANCHOR WATCH ALARM OFF 0.010nm
PROXIMITY ALARM OFF
XTE ALARM OFF 0.050nm
SPEED ALARM OFF
TRIP ALARM OFF 0000.0nm
ALARM INFORMATION
NO ALARM
BOTTOM ALARM OFF
TEMPERATURE ALARM OFF
ALARM INFORMATION
NO ALARM
NEXT
PAGE
D
NEXT
PAGE
D
PREV.
PAGE
E
RETURNE
EDITA
EDITA
CLEAR
ALARM
C
CLEAR
ALARM
C
PREV.
PAGE
E
Plotter alarm menu
3.11.1 Audio alarm on/off
Audio and visual alarms are released whenever an alarm setting is violated. You
can enable or disable the audio alarm as follows:
1. Press the [ALARM] key to show the alarm menu.
2. Use the trackball to select AUDIO ALARM.
3. Press the A:EDIT soft key to show the audio alarm window.
AUDIO ALARM
INT & EXT BUZZ
INTERNAL BUZZ
OFF
Audio alarm window
4. Use the trackball to select INT & EXT BUZZ (Internal + External alarm),
INTERNAL BUZZ (Internal alarm) or OFF as appropriate. This turns on or off
the audio alarm globally for all alarms, including radar.
5. Press the C:ENTER soft key.
6. Press the [ALARM] key to finish.
offered by Busse-Yachtshop.de