Filter
Top Products
Installing and Configuring the PassageWay
Service Provider
2-2
New PassageWay Solution Users
This section applies to new PassageWay Solution users. If you have an
existing version of PassageWay Solution, proceed to the next section,
“Existing PassageWay Solution Users.”
If you are a new PassageWay Solution user, perform the following steps:
1. Read the section “PassageWay Service Provider Components” to
make sure that you have all of the PassageWay Service Provider
components.
2. Read the section “PassageWay Service Provider Requirements” to
make sure that you have the required hardware and software to run
the PassageWay Service Provider.
3. Read the section “Before You Begin” to make sure that you have the
necessary information to set up and configure the PassageWay
Service Provider.
4. Connect your PassageWay adapter to your PC and your telephone by
performing the procedures in the section “Installing the PassageWay
Adapter.”
5. Install and configure the PassageWay Service Provider software by
performing the procedures in the section “Installing the Software.”