Filter
Top Products
Installing and Configuring the PassageWay
Service Provider
2-3
Existing PassageWay Solution Users
This section applies to users who have an earlier version of PassageWay
Solution installed. If you do not have an existing version of PassageWay
Solution installed, refer to the previous section, “New PassageWay Solution
Users.”
If you have an earlier version of PassageWay Solution installed on your PC,
perform the following steps:
1. Read the section “PassageWay Service Provider Components” to
make sure that you have all of the PassageWay Service Provider
components.
2. Read the section “PassageWay Service Provider Requirements” to
make sure that you have the required hardware and software to run
the PassageWay Service Provider.
3. Read the section “Before You Begin” to make sure that you have the
necessary information to set up and configure the PassageWay
Service Provider.
4. Install and configure the PassageWay Service Provider software by
performing the procedures in the section “Installing the Software.”