Filter
Top Products
DSM250 User’s Manual
Page 96 Revision 1.4.16a
6.12 Maretron FFM100 Configuration
The DSM250 is capable of configuring the Maretron FFM100 Fluid Flow Monitor. This describes the
configuration of the Maretron FFM100 firmware version 1.1.1.2.
Figure 88 – FFM100 Configuration Screen
6.12.1 Advanced Configuration
Advanced Configuration changes some complex parameters within the device, and should only be
performed by an advanced user. Typically advanced configuration is only done at installation and
should not need to be done while at sea.
Figure 89 – FFM100 Advanced Configuration
6.12.1.1 Device Instance
This entry allows you to program the NMEA 2000 device instance for the unit. You usually will not
need to modify the default value of “0” unless you have multiple units on the network.
6.12.1.2 Channel 0 Installation
Leave this entry at the default value of “Normal Installation” if the flow sensor connected to Channel 0
of the FFM100 is installed such that the direction of the fuel flow is in the same direction as the arrow