Filter
Top Products
DSM250 User’s Manual
Page 146 Revision 1.4.16a
6.19.6 Gauge Resistance, + to Sender
If the desired operating mode is “NMEA 2000 & Analog Gauge”, the two gauge resistances must be
programmed (please refer to the RAA100 User’s Manual for details on how to perform these
measurements). A screenshot of the + to sender gauge resistance configuration is shown in Figure
154 below. To program the + to sender gauge resistance, use the Scroll Up ( ) or Scroll Down (
) keys to move the highlighted cursor over the “Gauge Resistance, + to Sender:” menu item.
Then, press the Enter key ( ) to move the highlight over the numerical resistance value. Use the
“Increase” and “Decrease” keys to change the value to the measured resistance value, and finally,
press the Enter key ( ) to confirm your selection and store the value within the RAA100.
Figure 154 – RAA100: Setting the + to Sender Gauge Resistance
6.19.7 Gauge Resistance, - to Sender
If the desired operating mode is “NMEA 2000 & Analog Gauge”, the two gauge resistances must be
programmed (please refer to the RAA100 User’s Manual for details on how to perform these
measurements). A screenshot of the - to sender gauge resistance configuration is shown in Figure
155 below. To program the - to sender gauge resistance, use the Scroll Up ( ) or Scroll Down (
) keys to move the highlighted cursor over the “Gauge Resistance, - to Sender:” menu item. Then,
press the Enter key ( ) to move the highlight over the numerical resistance value. Use the
“Increase” and “Decrease” keys to change the value to the measured resistance value, and finally,
press the Enter key ( ) to confirm your selection and store the value within the RAA100.