Filter
Top Products
DSM250 User’s Manual
Page 232 Revision 1.4.16a
• Enable
• Disable
The desired option is selected using the Scroll Up and Scroll Down buttons, and then pressing the
Enter button again.
8.3.13 Operating Mode Anchored
See section 4.3.4 for a description of Operating Modes. For this Alert to be triggered when the vessel
is in the Anchored state, this option must be set to Enabled. The options here are
• Enable
• Disable
The desired option is selected using the Scroll Up and Scroll Down buttons, and then pressing the
Enter button again.
8.3.14 Scope
Alerts may be constrained to be displayed only on the DSM250 where they are detected. In this case
the Alert message is not sent out on the NMEA2000 bus, and other devices will not display the alert,
or allow Accepting of Cancelling. The Scope does not affect the generation of Annunciator messages.
The options here are
• Local – the Alert messages are not transmitted
• Global – the Alert messages are transmitted
The desired option is selected using the Scroll Up and Scroll Down buttons, and then pressing the
Enter button again.
8.4 Deleting an Alert
From the Alert Setup Menu, selected the menu item Delete Alert… .
Figure 272 – Deleting an Alert