Filter
Top Products
DSM250 User’s Manual
Page 196 Revision 1.4.16a
Figure 230 – Setting the Barometric Pressure
Use the Increase and Decrease buttons to select the correct pressure, and the press the Enter
button to store it.
6.30.6 Outside Humidity
The Humidity is pre-calibrated before leaving the factory, and should not require adjustment. However
the current humidity level may be entered in this screen to re-calibrate the WSO100 should this be
required.
Figure 231 – Setting the Outside Humidity
Use the Increase and Decrease buttons to select the correct humidity, and the press the Enter
button to store it.
6.30.7 Outside Temperature
The Temperature sensor is pre-calibrated before leaving the factory, and should not require
adjustment. However the current temperature may be entered in this screen to re-calibrate the
WSO100 should this be required.