Filter
Top Products
Revision 1.4.16a Page 151
®®
6.21 Maretron SIM100 Configuration
This describes the configuration of the Maretron SIM100 firmware version 1.1.1.
The DSM250 may be used to configure the channels on the Switch Indicator Module (SIM100).
After selecting the SIM100 from the list of devices on the network, the following screen will be
displayed.
Figure 160 – SIM100 Configuration Screen
6.21.1 Advanced Configuration
Advanced Configuration changes some complex parameters within the device, and should only be
performed by an advanced user. Typically advanced configuration is only done at installation and
should not need to be done while at sea.
Figure 161 – SIM100 Advanced Configuration Screen
6.21.1.1 Device Instance
This entry allo
ws you to program the NMEA 2000 device instance for the unit. You usually will not
need to modify the default value of “0” unless you have multiple units on the network.