Filter
Top Products
DSM250 User’s Manual
Page 132 Revision 1.4.16a
6.17 Maretron J2K100 Configuration
This describes the configuration of the Maretron J2K100 firmware version 1.0.7. The DSM250 is
capable of configuring settings for the J1939 to NMEA 2000® Gateway (J2K100). A screenshot of the
J2K100 configuration menu is shown in Figure 132 below.
Figure 132 – J2K100 Configuration Screen
6.17.1 Advanced Configuration
Advanced Configuration changes some complex parameters within the device, and should only be
performed by an advanced user. Typically advanced configuration is only done at installation and
should not need to be done while at sea.
Figure 133 – J2K100 Advanced Configuration Screen
6.17.1.1 Data Damping
In order to smooth the results viewed on a display, you may individually change the data
damping period that the J2K100 uses when sending fuel rate and tachometer (engine RPM)
information. The default is to use no damping (0.0 seconds). You may program the damping
from none up to 5 seconds.