Filter
Top Products
DSM250 User’s Manual
Page 154 Revision 1.4.16a
6.22 Maretron SSC200 Configuration
This describes the configuration of the Maretron SSC200 firmware version 2.0.11. Nine configurable
parameters for the Maretron SSC200 solid state compass may be configured using the Maretron
DSM250 display. The Maretron SSC200 configuration menu can be seen in Figure 164 below.
Figure 164 – SSC200 Configuration Screen
6.22.1 Advanced Configuration
Advanced Configuration changes some complex parameters within the device, and should only be
performed by an advanced user. Typically advanced configuration is only done at installation and
should not need to be done while at sea.
Figure 165 – SSC200 Advanced Configuration Screen
6.22.1.1 Device Instance
This entry allo
ws you to program the NMEA 2000 device instance for the unit. You usually will not
need to modify the default value of “0” unless you have multiple units on the network.