Mitsubishi Electronics FR-D740-012 Marine Battery User Manual


 
135
Monitor display and monitor output signal
4
PARAMETERS
(2) How to calibrate the terminal AM when using the operation panel
Operation Display
1.
Confirm the RUN indication and operation
mode indication
(When Pr. 158 = 1)
2. Press to choose the parameter setting
mode.
PRM indication is lit.
(The parameter number read previously appears.)
3. Turn until appears.
4. Turn until appears.
5. Turn until appears.
Set to C1 AM terminal calibration.
6. Press to enable setting.
7. If the inverter is at a stop, press the key
to start the inverter.
(Motor needs not be connected.)
8. Turn to adjust the indicator needle to the
desired position.
Analog indicator
9. Press .
Setting is complete.
Flicker...Parameter setting complete!!
Turn to read another parameter.
Press to return to the indication (step 4).
Press twice to show the next parameter ( ).
REMARKS
Calibration can also be made for external operation. Set the frequency in the external operation mode, and make calibration in
the above procedure.
Calibration can be made even during operation.
For operation from the parameter unit (FR-PU04/FR-PU07), refer to the instruction manual of the parameter unit.
Parameters referred to
Pr. 55 Frequency monitoring reference Refer to page 133
Pr. 56 Current monitoring reference Refer to page 133
Pr. 158 AM terminal function selection Refer to page 128
C1 to C7 settings
are enabled.
The monitor set to Pr. 158
AM terminal function selection
is displayed.