Filter
Top Products
245
Check and clear of the faults history
PARAMETERS
4
(2) Clearing procedure
POINT
Set "1" in Er.CL Fault history clear to clear the faults history. (Parameters are not cleared when "1" is set in Pr. 77
Parameter write selection.)
Operation Display
1. Screen at powering on
The monitor display appears.
2. Press to choose the parameter setting mode.
PRM indication is lit.
(The parameter number read previously
appears.)
3. Turn until (faults history clear)
appears.
4. Press to read the present set value. " " (initial
value) appears.
5. Turn to change it to the set value " ".
6. Press to set.
Flicker...Faults history clear complete!!
Turn to read another parameter.
Press to show the setting again.
Press twice to show the next parameter.
Parameters referred to
Pr. 77 Parameter write selection Refer to page 161