Filter
Top Products
54
Operation panel
4.1.3 Easy operation mode setting (easy setting mode)
Setting of Pr. 79 Operation mode selection according to combination of the start command and speed command can be
easily made.
Changing
example
Start command: external (STF/STR), frequency command: operate with
Operation Display
1. Screen at powering on
The monitor display appears.
2. Press and for 0.5s.
3. Turn until appears.
(refer to the table below for other settings)
4. Press to set.
Flicker ··· Parameter setting complete!!
The monitor display appears after 3s.
REMARKS
is displayed ... Why?
Parameter write is disabled with "1" set in Pr. 77.
is displayed ... Why?
Setting can not be made during operation. Turn the start switch ( , STF or STR) off.
Press before pressing to return to the monitor display without setting. In this case, the mode changes to external
operation mode when performed in the PU operation mode (PU JOG operation mode) and to PU operation mode when
performed in the external operation mode.
Reset can be made with .
The priorities of the frequency commands when Pr. 79 = "3" are "Multi-speed operation (RL/RM/RH/REX) > PID control (X14) >
terminal 4 analog input (AU) > digital input from the operation panel".
Flickering
Flickering
Flickering
Operation Panel Indication
Operation Method
Start command
Frequency command
External
(STF, STR)
Analog
voltage input
External
(STF, STR)
Analog
voltage input
Flickering
Flickering
Flickering
Flickering
Flickering
Flickering
Flickering
Flickering