Filter
Top Products
243
Initial value change list
PARAMETERS
4
4.24 Initial value change list
Displays and sets the parameters changed from the initial value.
Operation Display
1. Screen at powering on
The monitor display appears.
2. Press to choose the PU operation mode.
PU indication is lit.
3. Press to choose the parameter setting
mode.
PRM indication is lit.
(The parameter number read previously
appears.)
4. Turn until appears.
5. Pressing changes to the initial value
change list screen.
* It may take several seconds
for creating the initial value
change list.
" "
flickers while creating the list.
6. Turning displays the parameter number
changed.
Press to read the present set value.
Turn and press to change the
setting
(refer to step 6 and 7 on page 55)
Flicker Parameter setting complete!!
Turn to read another parameter.
The display returns to after all
parameters are displayed.
7. Pressing in status returns to
the parameter setting mode.
Turning sets other parameters.
Pressing displays the change list again.
NOTE
Calibration parameters (C1 (Pr. 901) to C7 (Pr. 905)) are not displayed even they are changed from the initial settings.
Only simple mode parameter is displayed when simple mode is set (Pr. 160 = "9999" (initial value))
Pr. 160 is displayed independently of whether the setting value is changed or not.
When parameter setting is changed after creating the initial value change list, the setting will be reflected to the initial
value change list next time.
Parameters referred to
Pr. 160 Extended function display selection Refer to page 162
C1 (Pr. 901) AM terminal calibration Refer to page 134
C2(Pr. 902) to C7(Pr. 905) (Frequency setting bias/gain parameter) Refer to page 153