25
2
WIRING
Control circuit specifications
3) Insert the wire into a socket.
When using a stranded wire without a bar terminal, push an open/close button all the way down with a flathead screw
driver, and insert the wire.
Wire removal
Pull the wire with pushing the open/close button all the way down firmly with a flathead screwdriver.
Note
When using a stranded wire without a bar terminal, twist enough to avoid short circuit with a nearby terminals or
wires.
Place the flathead screwdriver vertical to the open/close button. In case the blade tip slips, it may cause to damage of
inverter or injury.
Note
Use a small flathead screwdriver (Tip thickness: 0.4mm (0.02 inch)/tip width: 2.5mm (0.10 inch)).
If a flathead screwdriver with a narrow tip is used, terminal block may be damaged.
Place the flathead screwdriver vertical to the open/close button. In case the blade tip slips, it may cause to damage of
inverter or injury.
Open/close button
Flathead screwdrive
r
Open/close button
Flathead screwdrive
r