Filter
Top Products
C Commands Summary
MiLLennium GPSCard SW Version 4.503/4.52 Command Descriptions Manual Rev 2 89
CRESET
Configuration Reset. Resets user configuration to the factory default. After a reset, non volatile memory (NVM) is
read for user configuration. This command does not reset the hardware. See the Factory Default Settings.
Syntax:
See also the FRESET and RESET commands. These three commands differ in the following way:
RESET - Resets the hardware. Similar to powering the card off and on again.
CRESET - Resets user configuration to the factory default. This command does not reset the hardware.
FRESET - Completely resets the receiver to a factory state. Anything that was saved to NVM is erased
(including Saved Config, Saved Almanac and Channel Config). The hardware is also reset.
CRESET