Microplate Luminometer System Description
14
2.2.7 Connections on the Rear Panel
The Luminometer rear panel includes the connection ports, the
power switch, the fuses and the cooling element.
0
4
Power switch Power cord Fuses Cooling Injector PC port
Connector Element unit
data port
Connect the MONOLIGHT 3096 to the serial communication port
of the PC using the supplied 9-pin data cable (with two female
connectors).
Using the supplied cable (with two male connectors), connect
the MONOLIGHT 3096 injector unit (optional) to the 9-pin socket
of the MONOLIGHT 3096 and to the 15-pin socket on the injector
unit. Connect the instrument to wall socket via the supplied
power cable.
Line voltage and operating voltage must always match!
Observe a minimum distance of 10 cm between the back of
the instrument and the wall to allow air circulation for the
cooling element!
Voltage change, see section 8.3.
Fuse replacement, see section 8.2.
Figure 2-7:
Rear panel o
MONOLIGHT 3096
Luminometer
