Microplate Luminometer Structure of the Software
48
If the instrument door is not closed, a warning appears inform-
ing you about the current measurement mode:
Close the instrument door and click <Repeat> or <OK>. Then
the measurement starts.
Measurement procedure
The measurement procedure varies depending on the selected
measurement method.
Measurement end
The measurement is over when all selected wells have been
measured. In the autosave mode the measured results are
stored automatically and the measured values cleared from the
screen. If the autosave mode is not active the measured values
remain displayed and can be stored later.
Measurement stop
Press the Stop button (red signal light) to stop the measure-
ment. The results measured up to now can be stored.
Comment To enter a comment for the measurement, click the Comment
button. The text entered in the [Measurement Comment] dialog
box is printed in the report and saved to the data file.
Save You can save the measured results under any name by clicking
the Save button.
If you want to quit the measurement menu without saving the
data or if you click the button for new measurement
, you will
be prompted to save the data.
In the autosave mode, each measurement is stored automati-
cally and the file name (RD, SK or FK) is provided with a con-
secutive number.
