Microplate Luminometer Raw Data
61
Procedure with injections
Select the wells to be measured.
Place plastic tub in plate loading compartment.
Initialize injectors (
).
Prime injector tubing, if necessary (
). Insert microplate.
Insert microplate correctly in luminometer and close door.
If necessary, run background measurement (
).
Select the wells to be measured (
).
Start measurement (
).
Measurement start Measurement of the microplate or the selected area starts after
pressing the Start button (green signal light), when the instru-
ment door is closed.
The Start button is dimmed (gray) when a measurement is run-
ning, or no communication has been established with the lumi-
nometer, or the data of the last measurement have not yet been
saved. In all these cases, no measurement can be started.
If the instrument door is not closed, a message is displayed in-
dicating the current measurement mode:
Close the instrument door and click <Repeat> or <OK>. Then
the measurement will be started.
Measurement
procedure Any programmed injections will be performed and the selected
wells are measured one after the other. The results of the indi-
vidual samples are entered into the respective fields.
