Microplate Luminometer Structure of the Software
49
New measurement
a) When using the same measurement protocol:
In the autosave mode you can immediately start a new meas-
urement as soon as a measurement is finished. You can keep
the selected area or define a new area as describe above.
In the normal save mode, the measurement is cleared for the
next measurement when you click on the
button (= new
measurement), if the measured data of the last measurement
have already been saved. Otherwise you may continue only after
you have either saved the data or confirmed that you do not want
to save the data. Clearing means that the measured data of the
previous measurement are cleared from the screen and all tool
buttons are active again. You may keep the selected area or de-
fine a new one as describe above.
b) When using a new measurement protocol:
To load a new protocol you must to exit the measurement menu
via [File] / [Exit]. The program changes to the Protocol Manager
and you can select another measurement protocol and start
with <Run>.
Excel Transfer
To transfer the measured data to Excel, click the button. Ex-
cel is started – provided it is installed on your PC - and the
measured data are imported into an Excel spreadsheet.
