Microplate Luminometer Installation and Commissioning
23
3.6 Connecting the Injector Unit
The injector unit is supplied separately. Connect the injector unit
to the MONOLIGHT 3096 and then plug it in. A few simple steps
suffice to connect the injector unit, since the injector tubings are
already installed to the injector head of the luminometer and the
other end of the tubes includes the pre-fabricated pump con-
nection.
First, unplug the MONOLIGHT 3096 Luminometer from
wall socket.
Put the injector unit to the right of the MONOLIGHT 3096 and
pull the locking door of the injector unit off from above to ex-
pose the injector pumps.
Open the instrument door of the MONOLIGHT 3096.
Hold the service door on the left side and pull it off the Velcro
fastening. You will find 2 rolled up injector tubings.
Microplate loading area Injector head Injector unit
Tray for reagent bottles
Microplate Luminometer Injector Unit
Figure 3-3:
Microplate loading
compartment
and injector
(both devices open)
