SRS-1050 Installation ( Appendix B
Page B-18
For these features to work
properly, both the SRS-1050 and
the switch must be properly
configured.
The categories, described as “call
appearance reservation status”
that you may select are listed
below.
Originating only: allows certain
Directory numbers or call
appearances of Directory
Numbers to be used for
outgoing calls only.
Terminating only: allows certain
Directory numbers or call
appearances of Directory
Numbers to be used for
incoming calls only.
Originating only/Priority
Incoming only: allows certain
Directory numbers or call
appearances of Directory
Numbers to be used for
outgoing calls and for
incoming priority calls only.
Non-reserved: may be assigned
to lines that have no
reservation status.
The first step is to designate the
CA or Directory Number that you
will typically use for outgoing
calls. This is called the
Originating DN. If you do not
subscribe to Call Appearance
Reservation, you do not need to
follow the steps in Selection 7 or
Selection 8.
1. To manually assign the
Originating Directory Number
key for your SRS-1050, press 7,
ENTER to view the following
display:
ORIGINATING DN MODE
SELECT ASSIGN KEY
2. Press the selected Multi-assign
key.
ORIGINATING DN MODE
ORIGINATING DN = ON (1)
3. Press ENTER. The following
display is shown. You have the
option to turn the selected key
ON or OFF.
1:ON 2:OFF
SELECT ITEM (1-2)
4. Press 1 or 2 to change the
current status, or press ENTER
to accept the current status.
ORIGINATING DN=ON (1)
COMPLETED
Note: If an invalid key is
selected for the originating
Directory Number, the
following display is shown.
ORIGINATING DN REGISTRATION (XX)
INVALID SELECTION
