Chapter 4 ( SRS-1050 Data Operation
Page 4-1
CHAPTER 4
DATA OPERATION
The SRS-1050 Digital Set is
available in a voice/data model
that allows you to use the set for
data applications. Please refer to
the Fujitsu ISDN Data User's
Guide for information on how to
set up and configure the Terminal
Adapter for proper operation.
USING THE DATA TERMINAL
ADAPTER
This chapter describes three ways
to make a data call using the
integrated Terminal Adapter (TA)
in your Digital Set.
• Using the DATA softkey
(second button from the left
under the display)
• Using AT commands at your
terminal
There are three LEDs below the
multifunction buttons of the SRS-
1050. DTR (Data Terminal Ready)
must be steady green to establish
a connection.
Transmitting data from your
terminal causes the TXD
(Transmit Data) LED to flash, and
receiving data causes the RXD
(Receive Data) LED to flash.
MAKING AND TERMINATING
A DATA CALL
You can start or end a data call
either manually or by using
commands at your terminal, as
described in the following
sections.
Using the DATA Key
To make a data call using the
digital set DATA key, follow
these steps:
1. Press DATA (softkey 2).
To display the softkey names,
press KEY MENU.
Next to the word DATA on the
display, a blinking terminal
symbol appears, and to its left the
word SEND appears for about six
seconds.
. . . . . . . . . . . . . . . . . . . . . . . . . . .
SEND DATA CLEAR
2. Use the keypad to enter the
number you wish to dial (or
press a one-touch button), and
press SEND (softkey 1).
Note: The SEND key tells the
Digital Set to dial the number.
If you don't press SEND, the
Digital Set will dial the number
after a six second delay.
