Chapter 2 ( SRS-1050 Voice Features
Page 2-3
b. Press the button in the
handset cradle to get a dial
tone.
4. If your call is answered,
converse with the called party.
5. When your conversation ends,
hang up by replacing the
handset in its cradle. Note the
displayed call duration; it
vanishes after about three
seconds.
Note: Onhook dialing. In place
of steps 1 and 2, you can dial
the number first and then pick
up the handset. The phone
automatically dials the
number. The number you
enter remains available for
dialing for about three
minutes.
You can also use a one-touch
button, which automatically
selects an idle CA and dials
the number. Steps 1 and 2 are
therefore unnecessary when
you use a one-touch button.
Once the call is dialed, you
can pick up the handset.
If you are already talking on
another call
1. Handle the active call in one of
the following ways:
a. End the call by pressing the
button in the handset cradle
to get a dial tone. (You can
also hang up the handset
and pick it up again.)
