SRS-1050 Local Features ( Chapter 3
Page 3-16
Selecting Ringer Pattern
This selection determines the
type of ring that announces an
incoming call when you are
conversing on another line.
1. Press REG (softkey 4), 7, ENTER
(softkey 1). This screen
appears:
RINGER SERVICE MODE
. . . . . . . . . . . . . . . . . . . . . . . . . . .
2. Press ENTER again and this
menu appears:
1:VOLUME 2:TONE
3:RINGING (SELECT 1-4)
To see the next menu screen,
press NEXT (softkey 2):
4:PATTERN
(SELECT 1-4)
The selection you want appears
on the second screen of the
menu, which you can see by
pressing NEXT (softkey 2).
3. Press 4, ENTER. A screen
appears showing you the
current ringer pattern setting:
RINGER PATTERN MODE
MUTE RING
4. Press ENTER again and this
menu appears:
1:MUTE RING 2:ONE RING
(SELECT 1-2)
5. Select 1 for a mute ring, a normal
ring pattern at reduced volume,
or 2 for one ring, which rings
once at normal volume. Then
press ENTER. The screen
shows your selection plus the
word COMPLETED:
ONE RING
COMPLETED
6. To return to the normal display,
press REG (softkey 4).
Q.931 MESSAGE LOGGING
The Q.931 message logging
feature is not supported on this
set.
CALL ANNOUNCE INTERCOM
The Call Announce Intercom
feature is a convenient way for a
person screening incoming calls
to announce the call to the
intended recipient. The screener
places the incoming call on hold,
uses a designated Directory
Number to announce the call to
the recipient via intercom, and
may then transfer the call. The
screener can also use this feature
to deliver a message.
