Chapter 3 ( SRS-1050 Local Features
Page 3-21
To program the first number and
enable Call Announce Intercom,
go to step 2.
2. Press ENTER. The Call
Announce Intercom selection
screen appears:
1:ONE WAY 2:TWO WAY INTERCOM
3: TURN OFF (SELECT 1-3)
3. To enable the intercom feature,
dial 1 or 2 and press ENTER. A
screen appears showing your
choice and prompting for an
authorized Directory Number:
TWO WAY SELECTED (1)
ENTER TELEPHONE NUMBER
To disable the intercom feature,
dial 3 and press ENTER. When
the screen displays the message
INTERCOM TURNED OFF, press
REGISTER (softkey 4) to return to
normal operation.
4. Dial a telephone number of up to
ten digits (including wild cards)
and press ENTER (softkey 1).
When you press ENTER, a
screen appears announcing
ONE (or TWO) WAY TURNED
ON and showing the number
you entered:
TWO WAY TURNED ON
919*926*3112
If a Call Screener has Directory
Numbers identified by three, four,
or five digit extension numbers,
you can dial either the extension
number only or the full number.
You can also dial an asterisk as a
wild card character. See the
section introduction for a
complete explanation of these
choices.
Three Call Screeners can be
entered. To program the second
or third number, see step 5.
5. Press (*), 11, ENTER, repeat
steps 2,3, and 4 as needed until
this screen appears:
INTERCOM FEATURE (1)
(ONE OR TWO WAY) 919*926*3112
6. Press NEXT (softkey 2) and this
screen appears:
INTERCOM FEATURE (2)
NONSUPPORTED
Note the number (2) on the first
line indicating you are about to
program your second call
screener number. Pressing NEXT
repetitively at this prompt will
cycle you through all three call
screener selections to the one
you want to program or change.
Follow steps starting at # 2 to
program the last two numbers.
