Chapter 2 ( SRS-1050 Voice Features
Page 2-17
The TRANSFER button indicator
lights up.
The call is put on hold and its Call
Appearance indicator flashes red.
2. An idle CA/DN is selected. Dial
the number of the person you
want to transfer the call to.
• If the person answers, you
can talk privately before
completing the transfer. To
place this person on hold
without transferring the call,
press HOLD. To reconnect
with this person, press the DN
or CA button.
• If the line is busy or the
person does not answer, press
the button in the handset
cradle (press SPEAKER if you
are using handsfree mode).
Then press the flashing Call
Appearance button to return
to the original call.
Note: To do a "blind" transfer,
where you do not talk to the
person you are transferring
the call to, wait for the
person's phone to ring, press
the TRANSFER button, and
hang up.
3. You can complete the transfer
these two ways:
a. After announcing the
transfer, just press
TRANSFER and hang up.
or
b. To allow all three parties to
talk together, press the
flashing Call Appearance
button again; then press
TRANSFER when you want
to drop out.
4. Hang up the handset, or, in
handsfree mode, press
SPEAKER.
You are disconnected from the
call, leaving the other two parties
connected.
TRANSFER ( EWSD
Transfers a call to another
phone and announces the
transfer privately
Transfer is a network-based
feature that you must subscribe
to from your telephone company.
Note: In Siemens installations,
transferring calls is
accomplished without a
TRANSFER button.
To transfer a call, follow these
steps:
1. Answer the incoming call, then
while still on the call, press
CONFERENCE.
