Chapter 3 ( SRS-1050 Local Features
Page 3-23
If you deactivate MIC-OFF,
assign the upper right button as a
one-touch button, and then try to
reactivate MIC-OFF, the button's
LED turns red as a warning. You
must quit the procedure (press *
to return to the menu mode main
menus) and cancel the one-touch
number before you can reactivate
MIC-OFF.
If you try to reactivate MIC-OFF
without doing this, the message
INVALID SELECTION appears
and your attempt fails.
If you are deactivating the MIC-
OFF button, make sure the
function is turned off (the LED is
unlit) before beginning the
procedure.
To activate or deactivate MIC-
OFF, follow these steps:
1. Press REG (softkey 4), 12,
ENTER (softkey 1). A screen
appears showing you the
current status of MIC-OFF.
MIC-OFF KEY MODE
NON SUPPORTED
2. Press ENTER again and this
menu appears:
1:SUPPORT 2:NO SUPPORT
(SELECT 1-2)
The LED next to the upper right
button indicates its current state:
• Off: Unassigned
• Green: Already active as
MIC-OFF
• Red: Assigned as a one-
touch
If you wish to reactivate MIC-
OFF, you must first cancel the
one-touch assignment on the
upper right button.
3. To activate MIC-OFF, press 1,
ENTER.
To deactivate MIC-OFF, press
2, ENTER.
The screen shows your choice:
SUPPORTED
COMPLETED
4. To return to normal operations,
press REG (softkey 4). The
standard display screen
appears.
SELECTING CALL
APPEARANCE PREFERENCE
The preference options determine
which Call Appearance button the
SRS-1050 selects when you go
offhook (lift the receiver or press
SPEAKER). You have three
choices.
• Primary line preference. The
SRS-1050 always selects
button number 1, the Call
Appearance associated with
your primary Directory
Number.
