SRS-1050 Installation ( Appendix B
Page B-20
If you do not assign a DCA, the
SRS-1050 will automatically select
a default call button.
1. To manually assign the
Designated Call Appearance
key for your SRS-1050, press 9,
ENTER to view the following
display:
DESIGNATED CA MODE
SELECT ASSIGN KEY
2. Press the selected Multi-
assign key.
DESIGNATED CA REGISTRATION
DSGN CA = ON (1)
3. Press ENTER. The following
display is shown. You have the
option to turn the selected key
ON or OFF.
1:ON 2:OFF
SELECT ITEM (1-2)
4. Press 1 or 2 to change the
current status, or press ENTER
to accept the current status.
DSGN CA=ON (1)
COMPLETED
Note: If an invalid key is
selected for the Designated
Call Appearance, the
following display is shown.
DESIGNATED CA REGISTRATION (XX)
INVALID SELECTION
PROGRAMMING AND
LABELING THE SET
Refer to Chapter 3 for procedures
to:
• Enable headset use and turn off
handsfree mode, if desired.
• Set operating parameters such
as ringer volume and tone.
• Program the calendar/clock and
other local features.
To label the buttons on the set,
you must first remove the plastic
cover over the front panel. Insert
a pointed object into the semi-
circular notch at the bottom
middle of the plastic cover and lift
the cover upward.
Below the cover is a template.
Write button labels on this
template to show the directory
numbers or features assigned to
each button. Then lay the
template back on the front panel.
Reinsert the plastic cover.
