SRS-1050 Installation ( Appendix B
Page B-8
Key Attribute Configuration
Before attempting to load or
modify network data, obtain the
current configuration from your
service provider. This
configuration information should
show the Directory Numbers/Call
Appearances, the features (with
their feature numbers), and the
SRS-1050 button to which each
Directory Number/Call
Appearance or feature is
assigned.
Button assignments fall into three
categories: Directory Numbers,
Call Appearances, and Features.
If you must manually configure
your set, or if you want to
rearrange the button assignments
on your set, you must use the
following method. If you plan to
change a button assignment from
one category to another (e.g. Call
Appearance to Directory Number)
you must first cancel the current
assignment and add the new
assignment. For changes within a
category (call forwarding to call
pick-up), simply replace the old
data with the new data.
To load, modify, or update your
set's network data, begin with
these steps:
1. Press KEY MENU, then
REGISTER (softkey 4), 10,
ENTER (softkey 1). This screen
appears:
KEY ATTRIBUTE MODE
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . .
2. Press ENTER again to display
the set-up options.
1: DL 2: MANUAL
SELECT ITEM (1-2)
You can either automatically
download the configuration or
set-up each item manually. Each
method is described in the
following sections.
Download
Key Attribute selection 1,
“Downloading”, may be used to
request a download after initial
installation.
1. To automatically download the
configuration, press 1, ENTER.
The following displays are
shown during processing.
DL EXECUTING
UNA DATA CLEAR
REGISTER
DL COMPLETED
UNA DATA CLEAR
REGISTER
