SRS-1050 Voice Features ( Chapter 2
Page 2-4
or
b. Retain the call by pressing
an idle Call Appearance
button to get a dial tone.
(The call is automatically put
on hold.)
2. To make your call, dial the
desired number by pressing the
keys on the numeric keypad.
3. If your call is not answered, you
can hang up as follows:
a. Replace the handset in its
cradle.
or
b. Press the button in the
handset cradle to get a dial
tone.
4. If your call is answered,
converse with the called party.
5. When your conversation ends,
you have these choices:
• Hang up by replacing the
handset in its cradle. Note the
displayed call duration; it
vanishes after about three
seconds.
• If you put your original call on
hold, pick up the call by
pressing its red-flashing Call
Appearance button.
Note: You can also use a one-
touch button after handling
the active call. This
automatically dials the
number. Skip step 2.
Receiving Handset Calls
An incoming call makes the
phone ring and the Call
Appearance's LED flash green.
If you are not talking on
another call
1. Pick up the handset. (Press the
ringing CA if necessary.) The
LED changes to steady red.
2. Converse with the calling party.
3. When your conversation ends,
hang up by replacing the
handset in its cradle. Note the
displayed call duration; it
vanishes after about three
seconds.
If you are already talking on
another call
1. Handle the active call in one of
the following ways:
a. End the call by pressing the
button in the handset cradle.
Then press the green-
flashing Call Appearance
button to answer the
incoming call.
