SRS-1050 Local Features ( Chapter 3
Page 3-24
If you have an incoming call on
button number 1, you are
immediately connected to the
call. If button number 1 is idle,
you get a dial tone. If you are
going offhook to retrieve a call
on hold on button number 1,
you must press the button to
reconnect to the call.
To be connected to an
incoming call on another
button, or to get a dial tone on
an idle button, press the button
either before or after you go
offhook.
• No preference. The SRS-1050
does not automatically select
any Call Appearance button
when you go offhook. You
must press the button you
wish to be connected to either
before or after you go offhook.
• Ringing line preference. The
SRS-1050 selects the Call
Appearance button that is
ringing with an incoming call.
If you have more than one
incoming call, the SRS-1050
selects any ringing Intercom or
Intercom Group feature button
first, and then selects the
button with the call that has
been ringing the longest. You
are immediately connected to
the call.
• Idle preference. The SRS-1050
selects a Call Appearance
button that is idle, if one is
available.
If you have no incoming calls, the
SRS-1050 selects the idle Call
Appearance with the lowest
button number and gives you a
dial tone.
To select a Call Appearance
preference, follow these steps:
1. Press REG (softkey 4), 13, and
ENTER (softkey 1). A screen
appears showing you the
current preference.
CURRENT MODE IS
PRIMARY
2. Press ENTER to display the
preference menu.
1:RINGING 2:IDLE
3:PRIMARY (SELECT 1-4)
To see the next menu screen,
press NEXT (softkey 2):
4:NO PREF
(SELECT 1-4)
