Appendix B ( SRS-1050 Installation
Page B-1
APPENDIX B
INSTALLATION
These instructions are intended
mainly for System Administrators
or service personnel or end users
that are installing the SRS-1050.
Installation of the SRS-1050
involves four main steps:
• Connecting the set to the
network.
It’s necessary to determine
the type of Telephone
Company switching
equipment in use for proper
connection to the Telephone
Company network.
Implementation procedures
vary from one manufacturer
to another.
Switch Manufacturer
DMS-100 Nortel
5ESS Lucent
EWSD Siemens
• Entering Service Profile
Identifiers (SPIDs) and a D-
channel Terminal Endpoint
Identifier (TEI) for packet-
switched data calls, as
required.
• Loading network data. This
may be accomplished by two
methods: 1) downloading of
features from the switch, or 2)
manual configuration of
multifunction buttons.
• Programming and labeling the
set.
UNA DATA CLEAR REG
1 2 3 4
Key Menu
Standard Softkey Layout
INSTALLING THE SRS-1050
ISDN equipment may be installed
in a number of configurations. In
most installations, the
supplementary equipment (NT1
and power) is located in a wire
closet in your building. If this is
the case in your installation,
please skip to the section below:
“Connecting to the network”.
In some installations, the NT1 and
power are located at the user's
desk.
Two drawings are included that
illustrate the connections you
may need to make when the
power and NT1 are located at the
user's desk.
