Filter
Top Products
Gimbal Mounting Bracket: Allows the NS 10 to be adjusted to the optimum viewing angle. To
adjust, loosen the knobs on the gimbal mounting bracket and adjust the unit for best visibility.
After adjusting, tighten the knobs and the unit will stay in position.
TURNING THE NS 10 ON AND OFF
If you have completely installed your NS 10, and the receiver, you
should test the installation, by reading through this section.
If you have not installed your NS 10, you are still able to experiment
with the capabilities of the NS 10. The 120 VAC adapter (Figure 10)
provided with your NS 10 allows you to power your unit from a
receptacle at home.
Note: AC adapters are not provided with some NS 1o International
models.
This is especially convenient when learning to use the NS 10, or for
entering a long multileg route from charts (Refer to section 1V,
“Simulator and Map Preview”).
IMPORTANT: The power adapter is intended to power the NS 10 for use with the simulator of for
input of navigation points etc. It does not supply sufficient current to power both the NS 10 and
the Receiver and is not intended for use in normal operation.
The built in simulator allows you to experiment with the many functions of your unit. The
remaining instructions can be followed either in simulator mode, or in actual operation.
Turn On Screens/Disclaimer
Press POWER After pressing this key, you will hear an audible chirp. This means that the NS
10 has accepted your input.