Filter
Top Products
Returning to the point can be done as quickly as you can turn your boat, or may be done months
later with equal accuracy. To precisely position your boat over the waypoint, you may want to
zoom into the smallest zoom range.
If you have traveled some distance from the waypoint, it may be necessary to adjust the map
range using zoom to ensure the waypoint of interest is visible on the screen. Use PICK to
illuminate the waypoint. (Refer to Figure 30)
The information shown on the right side of the display will give you accurate navigation
information; both distance and bearing, to help you return exactly to that point. This information is
updated once per second, so response time is not a factor.
You may want to change the temporary waypoint to a permanent waypoint giving it a symbol and
name as shown in section IV. Creating Permanent Waypoints.
Note: When the P STOR key is pressed, the temporary waypoint number will be displayed for
about three seconds.
Maintenance
Your Humminbird NS 10 is designed to give you years of trouble-free operation with
virtually no maintenance. Follow the simple procedures listed below to ensure your NS 10
continues to deliver top performance. For customer assistance call the toll free customer support
hotline listed on the rear of this cover.
If the unit comes into contact with salt spray, simply wipe the affected areas with a cloth
dampened in fresh water.
When cleaning the screen, use a chamois cloth and nonabrasive cleaner such as Windex
®. Do not wipe while dirt or grit is on the screen. Be careful to avoid scratching the screen.
The receiver may become dirty from constant exposure to the environment. Simply clean
the surface of the receiver with a liquid detergent. Do not paint the receiver surface as some
marine paints will inhibit the reception of the GPS signals.
Never leave your NS 10 in a closed car or trunk, especially in extreme temperatures.
Do not attempt to repair the NS 10 yourself. There are no user serviceable parts inside
the unit, and opening the housing will void your warranty and will probably damage the waterproof
seal.