Filter
Top Products
Press ' once, and you will notice a DIST mode indicator appearing in the lower part of the
graphics area.
Press DIST, again to define the point you want to know the distance to.
Note: If you use PICK to identify the first point for the DIST function, then you must continue using
only PICK.
Note: DIST is a mode so pressing CLEAR will cancel it at any time.
Alarm Settings
There are three alarms that you may set on your NS 10. An an arrival alarm, off course
alarm and an anchor alarm.
ARRIVAL: This alarm will sound when you are within the specified range of your destination, or
interim waypoint. It will only sound while you are traveling a temporary or permanent route.
OFF COURSE: This alarm will only sound if you are traveling a temporary or permanent route.
ANCHOR: This alarm will sound when you leave the specified range of the anchor position.
When an alarm is activated an audible warning will be heard accompanied by an on
screen message. Press CLEAR to acknowledge the warning and reset the alarm.
Press SELECT to enter the MAIN MENU.
Use the up/down arrows to highlight ALARM.
Press ENTER when the setting is correct. The ALARM menu will be displayed.
Use the up/down arrows to highlight ARRIVAL.