- A-4 -
(4) Emergency stop
(5) Maintenance, inspection and parts replacement
(6) Disposal
(7) General instructions
CAUTION
• Provide a safety backup such as an emergecy brake which will prevent the machine and equipment
from hazardous conditions if the high power factor converter fails.
• When any protective function is activated, take the corresponding corrective action, then reset the
inverter, and resume operation.
CAUTION
• Do not carry out a megger (insulation resistance) test on the control circuit of the high power factor
converter.
CAUTION
• Treat the equipment as industrial waste.
Many of the diagrams and drawing in this instruction manual show the equipment without a cover, or
partially open. Never run the inverter like this. Always replace the cover and ensure adequate cooling,
etc. before using the product.