Filter
Top Products
4-40 Upgrading Your System
Note:
Observe static precautions. Use an antistatic wrist strap.
4. The drive carrier is shipped with the add-on drive. Remove the new drive from its
protective wrapper and place it on an antistatic surface. Record the drive model and
serial numbers in the equipment log.
5. Position the drive so its SCA connector is near the top surface of the drive. Place the
drive on the antistatic surface again. Slide the drive into the carrier with its SCA
connector facing toward the front of the carrier (open end).
6. While holding the drive in the carrier with your left hand, align the drive’s screw
holes with the carrier’s screw holes and insert the four screws of appropriate size
and length (see Figure 4-26).
7. Pressing the lock button on the carrier handle, open the handle. Align the
drive/carrier assembly so it engages the guide rails in the hard drive cage (see
Figure 4-27).
A
D
C
Installing 3 1/2inch hard disk drive
in carrier for hot-swap bays
A Carrier
B Four screws
C Hard disk drive
D SCA connector
Figure 4-26. Installing Hard Disk in Carrier