Filter
Top Products
Configuring Your System 3-19
4
A
B
ON
2143
DIP
Function Select Switches and Dump
Button
A Function select switches
B Reserved
Figure 3-1. Function Select Switches
Note:
The switches are set correctly at the factory for
your system configuration. If your system requires a switch
change, change only the switch setting for that condition.
Otherwise keep the switches at their factory settings.
Table 3-9 shows the switch configurations and functions. Set the switches per
Table 3-9 and the following steps. To change a switch setting, use the following
procedure.
Note:
Power must be completely off before setting the
switches, otherwise the settings will not be recognized.
1.
At the front of the server, press the Power switch off.
2.
At the rear of the server, locate the Function Select DIP switch (see Figure
3-1) that you want to change.
3.
Set the appropriate switch on or off, according to Table 3-9.
Note:
If you set SW3 to On for use with an optional
UPS unit, power the unit up before switching power on the
server.
4.
Press the main Power switch on.
If using an UPS unit, the server powers up as soon as the UPS unit is
turned on.
If not using the UPS unit, press the Power button on the front of the
server.