Filter
Top Products
3-8 Configuring Your System
17. The Steps in configuring your computer screen is displayed. At this screen
select “Step 5: Save and exit” and press
Enter
.
18. The Save and exit screen is displayed. At this screen select “Save the
configuration and restart the computer” and press
Enter
.
19. The Reboot screen is displayed. At this screen press
Enter
.
20. Now that you have reserved the system resources, you can install the ISA
board.
BIOS Setup Utility
The BIOS Setup Utility, like the RCU, is used to change system configuration
parameters. This utility has several unique parameters and many parameters that
are also configurable with the RCU. The utility is resident in the system FLASH
memory and does not require a diskette or an operating system present to run.
However, some parameters set with the BIOS Setup Utility that can also be set
with the RCU, are overwritten by the RCU the next time the RCU is run.
Using the BIOS Setup Utility
You access the BIOS Setup Utility when you turn on or reboot your system. To
run the BIOS Setup Utility, perform the following procedure.
1. Power on or reboot the system. BIOS displays the following:
Press <F2> to enter SETUP
2. Press
F2
. After BIOS POST completes, the BIOS Setup Utility starts and the
Main Menu is displayed. The menu bar at the top of the Main Menu lists the
following selections.
Menu Use
Main Use this menu for basic system configuration.
Advanced Use this menu for setting the Advanced Features available on your
system.
Security Use this menu to set User and Supervisor Passwords and the Backup
and Virus-Check reminders.
Server Use this menu for configuring Server Features.
Exit Exits the current menu.
Use the arrow keys to select a menu or an item on a displayed menu. Press
the value keys (listed in the table below) to cycle through the allowable
values for the selected field. Use the Exit menu’s “Save Values” selection to
save the current values on all the menus.
To display a submenu, position the cursor on a selection that has a submenu
and press
Enter
. Selections with submenus are preceded by an arrow.