Filter
Top Products
Page 13CPV550
2.2 FLUSH MOUNTING
The CPV550 is supplied with a flush mount template for the cutout hole and screw holes
required to install the GPS Chart Plotter.
NOTE
Before drilling holes ensure there are no obstructions behind the location that could interfere with
the mounting and there is physically enough room to mount the CPV550.
1. After a location is found, peal the template label from the backing and apply the label
to the mounting area.
2. Drill a hole in one area of the cut area that will allow the blade of a jig saw to be inserted.
Insert and cut out the area on the panel using the jig saw.
3. Next drill the four holes required to insert the CPV550 with the mounting studs.
4. Install the mounting studs on the CPV550 and insert into the mounting hole.
5. Attach the CPV550 to the mounting location by attaching the supplied hardware to the
mounting studs.
Figure 2.2 - Installing GPS Chart Plotter (Flush)