Filter
Top Products
System Manager/Zone Coordinator User’s Manual 25
428516-YUM-B-0908
Setup Procedures
Setup procedures include:
• Setting date and time parameters
• Changing the administrator or operator password
• Enabling/disabling the password requirement and remote user interface
• Setting up the modem
• Specifying Ethernet settings
• Selecting display units
• Calibrating the touch screen
• Specifying system manager name, zone coordinator name, and job name
Figure 11 is a flowchart of the Setup menu structure for the System Manager and Zone
Coordinator. These menu selections are described in the sections that follow.
Figure 11: Setup Options - Menu Structure
Setup
Zone
Coordinator
(See following Note.)
System
Manager
FIG:StupFlw
Security
(password)
Time
Management
Ethernet
Setup
Display
Setup
Modem
Setup
Change
Operator
Password
Change
Administrator
Password
Enable/Disable
Remote User
Interface
• Daylight Savings Time
• Current Date
• Current Time
• Time Zone
• Time Display
• DHCP Enabled
• Obtain DNS Address
Automatically
• Ethernet MAC Address
• Computer Name
• Domain Name
• IP Address
• IP Mask
• IP Router Address
• 1st DNS Server IP Address
• 2nd DNS Server IP Address
• Display Units
• Language
• Allow Incoming Connections
• Baud Rate
• Wait for Dial Tone Before Dialing
• Extra Initialization Commands
System
Manager/
Coordinator
Name
Job Name
If you perform Zone Coordinator setup from a System Manager, some
selections are not available because they are under the control of the System
Manager or are operations only done locally at the Coordinator. They include
Time Management, Display Setup, Alarm Setup, Security (Password), and Job
Name.
Note:
Calibrate Touch
Screen
Enable/Disable
Security (Password)