Filter
Top Products
8
INSTALLATION
(3) Install the option protective cover.
(4) Securely fit the connector of the plug-in option to the inverter connector along the guides.
(5) Securely fix the both top and bottom of the plug-in option to the inverter with the accessory mounting
screws. (tightening torque 0.45N
•m to 0.55N•m) If the screw holes do not line-up, the connector may
not have been plugged snugly. Check for loose plugging.
(6) Remove the PU cover provided on the front cover for plug-in option and install the other PU cover,
which was removed in (2).
(7) Loosen the terminal screw and insert the cable into the terminal. Tighten each cable with fixing screws
to the recommended tightening torque. (Refer to Chapter 3 for wiring.)
(8) Install the front cover for plug-in option to the inverter.
REMARKS
• When the option protective cover is not installed, the protective structure (JEM1030) changes to open type (IP00).
(4)
(5)
(7)
(8)
Option
connector
of inverter
(3) Option protective cover
Front cover
for plug-in option
(6) Replace
Mounting
screws