Filter
Top Products
70
PPO TYPE NON-SUPPORT SPECIFICATION
(2) PZD
Name Bit Definition
ZSW
Inverter running
(RUN signal)
0
0 : OFF
1 : ON (inverter running)
• For master-to-slave messages (command
request), bits 0 to 7 are not used and must
be set to 0. The bit-wise data here do not
reflect Pr.190 to Pr.192 (output terminal
function selection).
• At command response, signals are the
same. Signals are not affected by settings
of Pr.190 to Pr.192 (output terminal function
selection).
Forward running 1
0 : Other than forward running
(during stop or reverse rotation)
1 : Forward running
Reverse running 2
0 : Other than reverse running
(during stop or forward rotation)
1 : Reverse running
Up to frequency
(SU signal)
3
0 : OFF
1 : ON (up to frequency)
Overload alarm
(OL signal)
4
0 : OFF
1 : ON (overload alarm)
⎯ 5 Not used (0 is returned)
Output frequency
detection
(FU signal)
6
0 : OFF
1 : ON (output frequency being
detected)
Fault output
(ALM signal)
7
0 : Inverter normal
1 : Inverter alarm occurrence
⎯
8 to 15 Not used (0 is returned)
HIW 0 to 15 Not used (0 is set)