Filter
Top Products
75
PPO TYPE NON-SUPPORT SPECIFICATION
8
(2) Inverter status/operation command
The inverter status can be monitored and operation command can be given from the master.
IND PNU Item
0100H AH
• Inverter status
Refer to ZSW on page 70 for details.
• Run command
*1 Signal names are initial values. Using Pr. 180 to Pr. 184, you can change output signal functions. Refer to the
inverter manual for details of Pr. 180 to Pr. 184.
*2 Inverter reset function is invalid.
Bit Name Definition
1
Forward rotation command
(STF signal)
0: OFF (Stop command)
1: ON (Forward rotation
start)
A starting command is input to the
inverter when the signal turns ON.
A stop command is given when
both signals turn ON
simultaneously.
2
Reverse rotation command
(STR signal)
0: OFF (Stop command)
1: ON (Reverse rotation
start)
3
High-speed operation command
(terminal RH function)
*1
Functions assigned to terminals RH, RM and RL are activated.4
Middle-speed operation command
(terminal RM function)
*1
5
Low-speed operation command
(terminal RL function)
*1
7 Second function selection (RT signal) 1: Second function is selected
8 Terminal 4 input selection (AU signal) 1: Terminal 4 input is the main speed setting
10 Output stop (terminal MRS function)
*1 Functions assigned to terminal MRS is activated.
12 Inverter reset (terminal RES function)
*1 Functions assigned to terminal RES is activated. *2
Other than
the above
− Not used (0 is set)